Filter
Top Products
Mopier Messages
Table 7-2 lists and describes mopier messages and suggests
recommended actions.
Table 7-2 Mopier Messages
Message Description Recommended Action
READY The default ready message. The
mopier is ready to use.
No action required.
OFFLINE The mopier is offline and cannot
print data.
Press [On[Line].
WARMING UP The mopier is warming up and is
not ready to accept data.
Wait until the mopier signals
READY.
POWER SAVE ON The mopier is in Power Save
mode. In Power Save mode all
control panel keys operate
normally. (See “Configuration
Menu” in Chapter 4.)
No action required. The job
prints when the fuser has
warmed (about 45 seconds).
PERFORM USER
MAINTENANCE
This message indicates that the
mopier requires routine
maintenance. It will replace the
READY message until it is cleared.
Purchase a maintenance kit
and install the new parts. Then
remove the message by
turning SERVICE MESSAGE=
OFF in the CONFIGURATION
MENU.
PRINTING
CONFIGURATION PAGE
The mopier is printing a
configuration page.
No action required.
PRINTING FONT LIST The mopier is printing a font list.
(Note that PCL/PostScript formats
are the same.)
No action required.
PRINTING DEMO PAGE The mopier is printing a
Demonstration Page.
No action required.
MOPY XX OF YY from
Tray n
This message indicates the
progress of the current job.
No action required.
INTERNAL TEST The mopier is conducting a test of
its components.
No action required.
PROCESSING JOB FROM
TRAY n
The mopier is working on a job
from the indicated tray.
No action required.
TRAY n LIFTING The mopier is lifting the paper tray
to its working position after paper
was loaded.
No action required.
Continued on the next page.
7
Maintenance &
Troubleshooting
EN Maintenance and Troubleshooting 7-35