Filter
Top Products
Input/Output (IO) Menu
This menu contains the items related to I/O buffering. See Chapter 2,
“Memory and Memory Management,” for additional information about
the I/O functionality of your mopier.
Table 4-12 presents the messages that will appear when you select each
of the menu items.
Table 4-12 IO Menu
Menus Item Explanation
IO MENU PARALLEL IO
SPEED=[HIGH,LOW]
The rate at which data is transferred to print a page.
IO TIMEOUT=
[5 SEC,
10 SEC,
15 SEC*,
20 SEC,
30 SEC,
60 SEC,
120 SEC,
180 SEC,
240 SEC,
300 SEC]
The time, measured in seconds, that the mopier
waits before ending an incomplete print job. Once
the item is selected, press [+] repeatedly to choose
the desired setting for best performance.
IO BUFFER=
[AUTO*,OFF,ON]
The portion of the mopier memory set aside to
hold incoming data. When this item is set to AUTO,
the memory set aside for I/O buffering is
automatically determined by the mopier based on
available memory. When it is set to ON, the size
can be manually adjusted. When it is set to OFF,
no memory is set aside. This menu item will NOT
appear in the menu until there is sufficient memory
available to allow I/O buffering. For PCL, the
standard 4 Mbytes of memory is sufficient. For
PostScript it will take more than 12 Mbytes of
memory. See Chapter 2 to learn how I/O buffering
improves performance.
Note: When you change the I/O buffer setting, all
downloaded resources are deleted, unless they
are stored on the mopier Hard Disk.
IO SIZE=
nnnK
Becomes visible only if IO BUFFER is set to ON. It is
used to set the size of the buffer. Once the item is
selected, press [+] repeatedly to reach the
increment value desired. If you hold down the [+]
key, the values speed the increments.
* Factory default.
4-28 Mopier Control Panel EN