Filter
Top Products
Table 4-9 Configuration Menu,
continued
Menu Item Explanation
CONFIGURATION
MENU
PERSONALITY=
[AUTO*,PCL,
POSTSCRIPT]
Allows you to select the mopier personality. AUTO
is the default.
AUTO CONTINUE=
[ON*,OFF]
Allows the mopier to resume printing after
noncritical errors occur. If ON is selected, the
mopier goes offline and the error message is
displayed for ten seconds. After ten seconds, the
mopier automatically returns to online.
RESOURCE SAVE=
[AUTO*,OFF,ON]
Sets resource saving to ON, OFF, or AUTO (which
automatically determines how much memory to
use for each installed personality). When set to
ON, you can select a specific amount of memory
for resource saving.
PCL MEM=nnnnnK
or
POSTSCRIPT MEM=
nnnnnK
This item becomes visible only if Resource Save is
set to ON. The value nnnnnK indicates the number
of KBytes of memory reserved for that personality.
The choices for this item range from 0 to the total
amount of available memory in the mopier in
100-KByte increments. Press [+] repeatedly to
increase reserved memory.
TONER LOW=
[STOP*,CONTINUE]
This item allows you to make the choice to stop or
continue printing after the mopier detects that
toner is low. When toner runs out, the printed page
may be blank.
PAGE PROTECT=
[ON,AUTO*]
PAGE PROTECT appears after a 21 PRINT OVERRUN
error has occurred. Try to simplify the format of the
job. If you must print the job “as is,” set PAGE
PROTECT to ON, then later return it to AUTO. Do not
leave PAGE PROTECT set to ON as it will degrade
performance.
* Factory default.
4
Mopier
Control Panel
EN Mopier Control Panel 4-25