Filter
Top Products
Printing to the Mailbox with Stapler
The Mailbox with Stapler can work in one of three modes: mailbox
mode, job separation mode, or stacking mode. The network or printer
administrator determines which mode of operation is chosen through an
HP network configuration utility, such as HP JetAdmin or HP LaserJet
Utility. You need to set up your mopier driver to reflect the mode chosen
by the administrator. Bidirectional environments automatically reflect
the administrator’s choices in your printer driver.
The mopier control panel displays different names for the mailboxes and
stapler, depending on which mode the driver is using.
In Mailbox Mode, if the
Control Panel says:
Then the physical
location is:
OPTIONAL OUTPUT BIN 1
Left Output Bin
OPTIONAL OUTPUT BIN
2
through 6
Mailbox 1-5
OPTIONAL OUTPUT BIN 7
Stapler Bin
In Job Separation or Stacking
Modes, if the Control Panel
says:
Then the physical
location is:
OPTIONAL OUTPUT BIN 1
Top Output Bin
OPTIONAL OUTPUT BIN 2
Mailbox bins
OPTIONAL OUTPUT BIN 3
Stapler Bin
Selecting the Mailbox with Stapler through the Software
You can select these output bins through your software application,
mopier driver, or from the mopier control panel. It is better to designate
the paper destination in your software or printer driver since you will
control to which output bin your job is sent. Otherwise, follow the
instructions below for setting the overall default mopier output bin
selection.
Note Where and how you make selections depends on your software
application or associated printer driver. The selection process may be
available only from within the printer driver. See Chapter 3 or your
application manual for more information.
5
Print Tasks
EN Print Tasks 5-27