Filter
Top Products
Configuration Menu
The items on the Configuration Menu allow you to set default
parameters for two-sided printing and binding. These menu items also
help you select the output bin, printing personality, auto continue, power
saving, resource saving, and page protection. They notify you when the
toner supply is low or service is needed. Table 4-9 presents the messages
that appear when you select each of these menu items.
Table 4-9 Configuration Menu
Menu Item Explanation
CONFIGURATION
MENU
SERVICE MESSAGE=
[ON,OFF]
Appears at approximately 350,000-image intervals,
when the PERFORM USER MAINTENANCE message
appears.
2-SIDED=
[OFF*,ON]
Allows you to select duplex (two-sided) printing as
the default printing mode.
BINDING=
[LONG EDGE*,
SHORT EDGE]
Allows you to control the binding edges of
duplexed documents. More information about
binding options is located in Chapter 5, “Print
Tasks.”
PAPER
DESTINATION=
[TOP OUTPUT
BIN*, LEFT
OUTPUT BIN,
OPTIONAL OUTBIN]
Allows you to select the default output bin. More
information about the output bins is located in
Chapter 5.
When an output bin is full of paper, printing is
stopped and one of the following messages is
displayed: REMOVE PAPER FROM TOP OUTPUT BIN
or REMOVE PAPER FROM OPTIONAL OUTBIN n.
Empty the bin to resume printing.
Note: The Left Output Bin does not cause the bin
full message to be displayed.
By selecting the Stapler as the output bin, you can
have your documents stapled.
ORIENTATION=
[PORTRAIT*,
LANDSCAPE]
Allows you to specify the orientation of the printed
page. The orientation setting in your software
application overrides the control panel setting.
POWER SAVE DELAY=
[1 HR*
2 HRS
3 HRS
OFF
15 MINUTES
30 MINUTES]
Allows you to change the setting for the time
interval the mopier remains inactive prior to
entering Power Save mode. Warm up time for the
mopier after the power save delay is approximately
60 seconds.
* Factory default.
Continued on the next page
4-24 Mopier Control Panel EN