Filter
Top Products
Testing a SIMM Board
Use the procedures below to print a self test to verify SIMM board
installation. Procedures are given for both memory and PostScript or
other personality SIMMs.
Verifying a Memory SIMM
1 Plug in the power cord and switch the printer ON.
2 After a few seconds, the On Line indicator should light and READY
should appear in the control panel display. If a printer message
appears, see the “Optional SIMM Board Troubleshooting” section in
Chapter 7, “Maintenance and Troubleshooting.”
3 Press [Menus] until TEST MENU appears.
4 Press [Items] until PCL CONFIGURATION PAGE appears.
5 Press [Select]*] to print a self test.
Locate “Total Memory” on the configuration page printout. This is the
amount of memory now installed in your printer. (See Chapter 4,
“Mopier Control Panel,” for more information.)
If the amount of memory has not increased since installing the SIMM, it
may not be installed correctly (repeat installation procedure) or it may
be defective. (See “Optional SIMM Board Troubleshooting” in
Chapter 7.)
C-4 Memory and Personality SIMM Installation EN