Filter
Top Products
107
7 Configuring a Point-to-Point
Node
This chapter provides step-by-step instructions for configuring
Point-to-Point links. (Point-to-Point links are sometimes referred to as
router links.) This manual assumes that you are using the guided
configuration capabilities of NMMGR.
Figure 7-1 shows the screen flow for configuring Point-to-Point screens.
Screens unique to Point-to-Point configuration are indicated by bold
boxed screens.
[FUNCTION] denotes the function key used at a screen to
invoke the next screen on the screen flow.
Figure 7-1 Point-to-Point Link Configuration Screen Flow
Open Config/
Directory File Screen
Main Screen
NS Config
Link Selection
Neighbor Gateway
Reachable Networks
Network Transport
Config
[OPEN CONFIG]
[NS]
[NEIGHBOR GATEWAY]
[ADD or MODIFY]
If you have not created
the config file, then
press the OPEN
CONFIG key a second
time.
[CONFIG NETWORK]
Neighbor Gateways
Link Selection
Point-to-Point Link
Config
[VALIDATE NETXPORT]
Validate Link,
Cross-validate
with SYSGEN
Shared Dial Node
Mapping Config
[GUIDED CONFIG]
Direct Connect/Dial
Node Mapping Config
[LINK ROUTING]
(TYPE DD or DC)
[LINKROUTING]
(TYPE SD)