Filter
Top Products
Chapter 7 123
Configuring a Point-to-Point Node
Configure Node Mapping
Step 7. Enter information for non-adjacent (remote) nodes in the same manner
in the fields provided. (You do not configure a phone number or security
string for non-adjacent nodes.)
Step 8. Press the
[Save Data] key to save the data on the screen. Proceed to
Chapter 10 , “Validating and Cross-Validating with SYSGEN,” and
press the
[Validate Netxport] key.
Figure 7-7 Using an @ for Mapping Non-Adjacent Nodes
Priority
Number from 1 to 99 that indicates which route has
precedence (priority) over another when there are
multiple routes to a destination. A route to a
destination that has a higher priority will take
precedence over a route with a lower priority.
Disable Route
Y (yes) or N (no) indicator that allows you to temporarily
disable a configured route. Leave the default (N) alone if
you do not want to disable the route.
Phone Number
Required if the link is a dial link. The field must be
blank if the target node is non-adjacent. Enter the
telephone number as a combination of decimal numbers
(0 through 9), dashes, and the following special
characters:
/ Separator used for automatic call units
that have second dial-tone detect.
E Optional end-of-number indicator.
D Three-second delay (used for European
modems and automatic call units that
require built-in delays).
# Defined by local phone system.
* Defined by local phone system.