Filter
Top Products
150 Chapter10
Validating and Cross-Validating with SYSGEN
Cross-Validate in SYSGEN
Cross-Validate in SYSGEN
Cross-validation is automatically done on the KEEP, TAPE, I/O, and
RDCC commands in SYSGEN.
Cross-validation ensures that there are no conflicts in the use of node
names, device classes, and physical paths between the data currently
contained in NMCONFIG.PUB.SYS and the system configuration data.
To cross-validate, use the SYSGEN facility (OP capability is required).
To use SYSGEN, type the following commands at the MPE prompt:
:sysgen sysgen> io
io> ld
(optional)
io> exit
sysgen> exit
The optional ld (list devices) command allows you to verify the
NMMGR devices that are configured. For more information, see System
Startup, Configuration, and Shutdown.
If you have completed the configuration process, proceed to Chapter 14 ,
“Operating the Network.”