Filter
Top Products
Chapter 8 131
Configuring a X.25 Node
Configure an X.25 Network Interface
Configure X.25 Virtual Circuits
The X.25 Virtual Circuit Configuration screen (#47) in Figure 8-3 is
displayed if you press the
[Config Directry] key from the X.25
Configuration screen (#48) in Figure 8-2. This screen lets you configure
the network directory.
Figure 8-3 X.25 Virtual Circuit Configuration Screen
Step 1. In the Remote node name field, type in the nodename of each remote
X.25 node on your network in the format
nodename.domain.organization. Also, if you need to be able to
perform a loopback DSLINE command to the local node, then enter the
local node’s name here as well.
Step 2. For each node, type the IP address of the node in the Remote IP
address field.
Step 3. To specify that calls can be made to a node, enter its address key in the
Address key field. Enter the node portion of the remote node’s
configured nodename.