Filter
Top Products
62 Chapter4
Planning for Node Configuration
Node Worksheet Information
Node Worksheet Information
Table 4-1, has a description of the information that needs to be
gathered for the worksheets that are in this chapter. Check the
worksheets to see which is the appropriate information to gather. This
information is used in the configuration chapters of this manual.
Table 4-1 Configuration Worksheet Information
Field Screen Description
Address key X.25 Virtual Circuit
Configuration
In the network directory, the name of
each node listed in the remote node
name field. HP recommends that you
use the node portion of the remote
node’s node name as the address key.
Card number X.25 Configuration Slot number of the DTC/X.25 Network
Access card.
DTC node name X.25 Configuration Node name of the DTC in the form
node.domain.organization. Must
agree with node name configured
through during configuration of the
datacommunications and terminal
subsystem (DTS). The node name
must be entered for each DTC/X.25
network access card that allows
system-to-system connections.
Enable ethernet/
Enable IEEE 802.3
LAN Configuration Both ethernet and IEEE 802.3 are
enabled by default. You may disable
one or the other but not both (one
must be enabled). To disable either
ethernet or IEEE 802.3, enter an N
(no) in the field next to the enable
question.
Facility set X.25 Virtual Circuit
Configuration
For SVCs only. A name for a collection
of X.25 connection parameters in the
network directory. Use the default
(STDSFSET) or enter a different
name, then go to Facility sets to define
parameters. It must match the
parameters specified by your network
subscription.