Filter
Top Products
160 Chapter11
Configuring the Network Directory
Configure Path Report Data for a Node
Configure Path Report Data for a Node
The Network Directory Data screen (#10) in Figure 11-5 is displayed
when you press the
[Add] or the [Modify] function key at the Select Node
Name screen (#9) in Figure 11-4.
Figure 11-5 Network Directory Data
The function of this screen is to configure path report data for the node
name listed at the top of the screen. One path report is configured for
each NI on a node. Because the maximum number of NIs per node is 48
(including loopback), each node can contain as many as 47 path reports.
Step 1. Verify that the yes and no indicators in the TCP, Checksum for TCP
required, and PXP fields are set correctly.
Step 2. In the IP address field, type in the IP address of the node listed in the
Node name field.
Step 3. In the type field, enter the number that indicates the type of the path:
1 = IP
2 = LAN/IEEE 802.3 (LAN, 100VG, 100BT)
3 = X.25 ACCESS
5 = ETHERNET (LAN 100VG, 100BT)
6 = Token Ring, 100VG/IEEE 802.5
7 = FDDI