Filter
Top Products
219
D PCI 10/100Base-TX/3000 Quick
Installation
The PCI 10/100Base-TX adapter card (A5230A) for the HP e3000
supports 10Mbits/s and 100Mbits/s Fast Ethernet operation as well as
full and half-duplex modes. Ensure that the speed, duplex, and
autonegotiation settings of the associated data hub or switch match the
settings on this card (as configured in the network configuration file,
NMCONFIG.PUB.SYS). Refer to the sections on “Notes on Manual
Speed and Duplex Mode Configuration” and “Notes on Autonegotiation
and Autosensing” in this appendix for background information on
determining these settings, if needed. For a detailed description of
using NMMGR to configure the 10/100Base-TX link in your
NMCONFIG file, see the NS 3000/iX NMMGR Screens Reference
Manual.
1. Verify the PCI 10/100Base-TX software is present in the installed
version of MPE/iX (must be 7.0 or later).
• Make sure MPE/iX 7.0 has been successfully installed on the
system. The PCI 10/100Base-TX software license is included with
MPE/iX 7.0. No additional software installation is required.
• Run the NMMAINT,78 command and verify complete version
information is displayed for the PCI 100Base-TX link software
(subsystem 78).
Sample output:
:nmmaint,78
NMS Maintenance Utility 32098-20014 B.00.10 (C) Hewlett Packard Co.
1984
WED, DEC 6, 2000, 11:12 AM
Datacom products build version: N.73.01
Subsystem version IDs:
Subsystem Number : 78
PCI 100Base-T Fast Ethernet driver module versions:
NL procedure: PCI_100BT_NL_VERS Version: A0070072
XL procedure: PCI_100BT_XL_VERS Version: A0070072
Catalog file: NMCAT78.NET.SYS Version: A0070072
NL procedure: LNK_NL_VERS Version: A0070004
NL procedure: WANDMPSURRVERS Version: A0070000
PCI 100Base-T Fast Ethernet driver ------- overall version = A.00.70