Filter
Top Products
148 Chapter10
Validating and Cross-Validating with SYSGEN
Validate the Network Transport
Validate the Network Transport
The following procedure assumes that you have already configured and
validated the Distributed Terminal Subsystem (DTS). The DTS must be
validated before you can validate the network transport (Netxport)
software. Upon configuring the selected screens for your network:
Step 1. Press the
[Validate Netxport] key. Refer to the list of screens with the
[Validate Netxport] key.
LAN, 100Base-T, or 100VG-AnyLAN — Figure 6-2
Token Ring — Figure 6-3
FDDI — Figure 6-4
Point-to-Point Shared Dial — Figure 7-5
Point-to-Point Direct Dial — Figure 7-6
X.25 — Figure 8-3
Gateway Half — Figure 9-2
Logging — Figure 13-2
Messages similar to the following ones will be displayed:
Searching for subsystem validation routine VALIDATEDTS
---> Validation of DTS/LINK started. <---
---> Validation of DTS/LINK finished. <---
NMMGR will now cross-validate the NMCONFIG file with SYSGEN.
SYSGEN version V.uu.ff : catalog version V.uu.ff WED, NOV 15, 2000, 11:10 AM
Copyright 1987 Hewlett-Packard Co. All Rights Reserved.
**note** Retrieving NMMGR configuration data...
** First level command **
io log (lo) misc (mi) spu (sp)
sysfile (sy)
basegroup (ba) keep(ke) permyes (pe) show (sh)
tape (ta)
clear (cl)(c) exit (ex)(e) help (he)(h) oclose (oc)
redo
sysgen> PERMYES ON
sysgen> BA CONFIG
sysgen> SY