Filter
Top Products
Appendix C 215
NS X.25 Migration: NS 3000/V PAD Access to NS 3000/iX
Migrating from NS 3000/V PAD Access to NS 3000/iX
Migrating from NS 3000/V PAD Access to
NS 3000/iX
There is no conversion tool for migrating NS 3000/V PAD access to
NS 3000/iX Release 2.0 or later.
The tasks you must do in order to migrate from NS 3000/V PAD access
to NS 3000/iX release 2.0 or later are as follows:
1. Make sure you have accounted for the differences that could affect
your network as described in the previous sections of this appendix.
2. Make a list of the NS 3000/V PAD data that must be re-entered for
the DTC. Refer to the section in this appendix called “To Save
NS 3000/V PAD Parameters.”
Using Host-Based Network Management
1. Use NMMGR to configure DTS parameters on the host.
2. Complete PAD configuration using NMMGR. For complete
information on this, see Configuring and Managing Host-Based X.25
Links.
• Remove PAD terminals from the NS 3000/V network directory.
Using PC-Based Network Management
1. Use NMMGR to configure DTS parameters on the host. For complete
information on this, read Configuring Systems for Terminals,
Printers, an Other Serial Devices.
2. Make a list of the DTS parameters configured on the host that must
also be entered into the OpenView DTC Manager. Refer to the
section in this appendix called “To Save DTS Parameters on the
Host.”
3. Configure the DTC by using the OpenView DTC Manager at your
OpenView Windows Workstation.
• Remove PAD terminals from the NS 3000/V network directory.
Saving NS 3000/V PAD Parameters
Make a list of the following NS 3000/V parameters that must be
re-entered on the DTC:
• PAD device X.25 addresses fro the NS 3000/V screen with the path:
@NETXPORT.NI.niname.PROTOCOL.X25.SVCPATH