Filter
Top Products
130 Chapter8
Configuring a X.25 Node
Configure an X.25 Network Interface
nodes per subnetwork you need. See
Chapter 2 , “Networking Concepts,” for
details on deriving an IP subnet mask.
Link Name The link name identifies a specific
DTC/X.25 Network Access card to be
used for X.25 system-to-system
connections. This link name must be
the same as the link name you entered
for this card when you configured your
DTCs. You may configure up to 11
links. (One link must be used for
loopback. Loopback will be
automatically configured during the
guided screen configuration.)
DTC Node Name The DTC node name is the fully
qualified nodename
(name.domain.organization) of the
DTC that contains the DTC/X.25
Network Access card with the
configured link name.
Card Number The DTC card number is the number of
the DTC/X.25 Network Access card in
the associated DTC. If the card is
contained in a DTC 48, the DTC card
number can be any number from 1 to 5.
If the card is contained in a DTC 16,
the card number must be 2.