Filter
Top Products
Chapter 8 137
Configuring a X.25 Node
Configure Neighbor Gateways
Identify Neighbor Gateway Reachable Networks
The Neighbor Gateway Reachable Networks screen (#158) in Figure 8-5
is displayed when you press the
[Add] key or the [Modify] key for a valid
gateway name from the Neighbor Gateways screen (#152) in Figure 8-4.
Figure 8-5 Neighbor Gateway Reachable Networks Screen
Step 1. In the Neighbor Gateway IP Internet Address field, enter the IP
address of the gateway specified on the Neighbor Gateways screen. An
example is: C 192.007.007 001
Step 2. In the IP Network Address fields under the title Configured
Reachable Networks, enter the IP addresses of all the remote
networks that can be reached through the gateway whose IP address is
configured in the previous field.
An “@” in the IP network address field designates the gateway as a
default gateway. It means this gateway can be used to reach all the
other remote networks.
Step 3. The IP subnet mask is optional. If entering one, tab to the next field. In
the IP mask field, enter the number in the same format as an IP
address.
Step 4. In the field labeled Hops, enter the number of hops (full gateways)
needed to get to the target network. Two partner gateway halves count
as one hop.
Step 5. Repeat steps 2, 3, and 4 for each remote reachable network. The
information configured in this screen can extend to more than one page,