Filter
Top Products
Chapter 14 189
Operating the Network
Start Links and Services
NOTE
If you are starting an X.25 link for a system using PC-based network
management or if you are not starting an X.25 link, you do not need to
use the DTCCNTRL command.
Start Network Services
Issue the following command (NM capability required) to start the
network services:
NSCONTROL START
This starts the NS 3000/iX Network Services, such as Virtual Terminal,
Network File Transfer, Remote File Access, and Remote Data Base
Access.
You may want to create a startup UDC or command file to activate
software loopback, the link(s), and the network services. If you do so,
you must separate each command with a brie pause to allow for
processing (rxample: “:PAUSE 5”).