Filter
Top Products
Chapter 8 127
Configuring a X.25 Node
Configure an X.25 Network Interface
Configure an X.25 Network Interface
The X.25 Configuration screen (#48) in Figure 8-2 is displayed when
you press the
[Config Network] key at the Network Transport
Configuration screen (#42) with an NI type of 3 (X.25). Refer to Chapter
5 , “Introductory Screens,” for information on the Network Transport
Configuration screen.
Figure 8-2 NS Configuration Screen
Step 1. In the IP address field, enter the internet protocol (IP) address for the
node being configured. An example of an address is:
C 192.191.191 009.
Step 2. The IP subnet mask is optional. If entering one, tab to the IP subnet
mask field and enter the number in the same format as an IP address.
Step 3. Move to the first Link name field. Enter a link name to represent the
DTC/X.25 Network Access card for which you are configuring a link.
This name must be unique to both the node and the DTC. It must also
be the same as the link name configured for this card when the
Datacommunications and Terminal Subsystem (DTS) was configured.
Step 4. Enter the node name of the DTC that houses the DTC/X.25 Access card
in the first DTC Node Name field then enter the slot number of the card
in the Card Number field. Enter a link name, DTC node name, and card
number for each link you are configuring.