Filter
Top Products
182 Chapter13
Configuring Logging
Modify the Logging Configuration
Fields Enable or disable logging classes (or accept HP-recommended defaults).
Press the
[Save Data] key on each screen to create or modify the data
record. Verify that the data record has been created by checking that
the Data flag is Y.
Console Logging
The value entered in this field specifies whether or not
logging events for the subsystem and class listed beside
the field will be logged to the system console. A value
must be entered for each subsystem and class listed. A
Y (yes) enables logging to the console, N (no) disables
logging to the console.
Disk Logging
The value entered in this field specifies whether or not
logging events for the subsystem and class listed beside
the field will be logged to a disk file. A value must be
entered for each subsystem and class listed. A Y (yes)
enables logging to a file, N (no) disables logging to a file.
The file name that NMS uses is NMLG
nnnn
.PUB.SYS,
where
nnnn
is a number from
0000
to
9999
. All logging
classes in all subsystems are logged to this file. At each
system startup, or when a file is full, NMS creates a
new NMLG
nnnn
.PUB.SYS file, naming each successive
logging file by incrementing
nnnn
. When
NMLG
9999
.PUB.SYS is full, NMS names the next
logging file NMLG
0000
.PUB.SYS.
The Netxport Log Configuration (7) screen (#353) in Figure 13-8 is
displayed when you press the [Next Screen] function key from the
Netxport Log Configuration (6) screen (#316) in Figure 13-7.