Filter
Top Products
Chapter 13 179
Configuring Logging
Modify the Logging Configuration
record. Verify that the data record has been created by checking that
the Data flag is Y.
Press the [Exit Logging] function key when you have finished modifying
the logging configuration.
Fields Console Logging The value entered in this field specifies
whether or not logging events for the
subsystem and class listed beside the
field will be logged to the system
console. A value must be entered for
each subsystem and class listed. A Y
(yes) enables logging to the console, N
(no) disables logging to the console.
Disk Logging The value entered in this field specifies
whether or not logging events for the
subsystem and class listed beside the
field will be logged to a disk file. A
value must be entered for each
subsystem and class listed. A Y (yes)
enables logging to a file, N (no) disables
logging to a file. The file name that
NMS uses is NMLG
nnnn
.PUB.SYS,
where
nnnn
is a number from
0000
to
9999
. All logging classes in all
subsystems are logged to this file. At
each system startup, or when a file is
full, NMS creates a new
NMLG
nnnn
.PUB.SYS file, naming each
successive logging file by incrementing
nnnn
. When NMLG
9999
.PUB.SYS is full,
NMS names the next logging file
NMLG
0000
.PUB.SYS.
The Netxport Log Configuration (5) screen (#69) in Figure 13-6 is
displayed when you press the [Next Screen] function key from the
Netxport Log Configuration (4) screen (#68) in Figure 13-5.