Filter
Top Products
Intermate100 and Intermate101 Print Server Administration Manual 152
[Logical Printers 1-8]: Target Printer
20.2. Target Printer
This parameter specifies the destination of the printed output
to be used in connection with the logical printer you are config-
uring.
If you are not using NDO, the only possibility is to keep the
default which is Local Printer (0).
If you are using NDO, you can choose among six possibilities
for a given logical printer:
“Local” is also referred to as the local port and refers to the
Centronics parallel port on the printer to which the
Intermate1xx is physically attached.
If you choose a Network Destination which has not been
defined in
“Network Destination Option” [page 144]
, and then
send a job to the logical printer in question, the job will be dis-
carded and an error message will appear in the System Log
(see
““Status > System Log”” [page 176]
). The same thing will
happen if you have defined a Network Destination, but have no
NDO license key installed (G22-based print servers).
If you choose “pool”, you must also fill in the next field in the
block defining the logical printer you are configuring.
Older print servers Newer print servers
Local(0) Local Printer (0)
Netw1(1) Network Destination 1 (1)
Netw2(2) Network Destination 2 (2)
Netw3(3) Network Destination 3 (3)
Netw4(4) Network Destination 4 (4)
Pool Pool