Filter
Top Products
Intermate100 and Intermate101 Print Server Administration Manual 188
Configure [SNMP]: Traps
26.5. Traps
Traps are used to monitor the printer and to report errors and
attempts of unauthorized user access.
The kinds of traps which are generated are controlled on the
Intermate1xx’s [SNMP] configuration page using the parame-
ters
Enable Authentication Traps
(Default setting = No) and
Enable SNMP Printer Traps
(Default setting = No).
The receivers of the traps are specified with
Trap Target
(Default setting = >Blank<). The receiver’s community is set
with
Trap Community
(Default setting = public).
The traps that can be generated based on printer events are
listed below.
Figure 18. SNMP Printer Trap Numbers
In addition to these come traps generated by unauthorized
attempts of viewing or editing options.
To set up traps
1
Start HP OpenView and choose the connection you wish to
work with.
2 On the main screen, choose “Options > Customize Traps”.
Printer trap no. Printer event Parameter Default Setting
1 Printer ready - -
4 Printer off-line
Trap on ’Off-line’
Yes
32 Out of paper
Trap on ’Out of Paper’
Yes
128 Cover open
Trap on ’Cover Open’
Yes
512 Paper jam
Trap on ’Paper Jam’
Yes
1024 Toner low
Trap on ’Toner Low’
Yes
8192 Undefined error
Trap on ’Printer Error’
Yes