Intermate 100 Printer User Manual


 
Intermate100 and Intermate101 Print Server Administration Manual 190
Configure [SNMP]: Traps
6 Close the “Customize Trap Alarms” box.
7 Log on to the Intermate1xx.
8 Choose “Configurations > Status Monitoring” > [SNMP] to
set the parameters you want.
Parameter Default Setting Comments
Monitor Community
public
Control Community
public
Trap Community
public
Set this to a value other than "public" if
you want to control who should receive
traps.
[Table is continued on the next page]
Trap Target
>Blank<
The receivers of traps are specified by
their IP addresses. IP addresses must be
entered with the ASCII character one as
lead-in, e.g.
1192.168.4.186
For Novell Netware under IPX/SPX (only
in G22-based servers purchased before
4 January 2002), (not applicable to
Intermate101
)
use the IPX/SPX address.
IPX/SPX addresses be entered with the
ASCII character zero as lead-in, e.g.
00000000400c0a20507f8
Enable Authentication
Traps
No
Set this to "Yes" if you want to enable
traps on attempts of unauthorized
access.
Enable SNMP Printer
Traps
No
Set this to "Yes" if you want to enable
traps on printer errors.
Trap on ’Off-line’
Yes
-
Trap on ’Out of Paper’
Yes
-
Trap on ’Paper Jam’
Yes
-
Trap on ’Cover Open’
Yes
-
Trap on ’Toner Low’
Yes
-