Filter
Top Products
Intermate100 and Intermate101 Print Server Administration Manual vii
Table of Contents
18.5.1.Report Compatible Mode PE as: ..................................................... 140
18.5.2.Report Compatible Mode ERROR as:............................................. 140
18.6.Special PJL Settings for ECP and Nibble .................................................. 141
18.6.1.PJL Printer Status Feedback Frequency......................................... 141
18.6.2.Check for Pending Printer Data When Idle For / Reverse Data ...... 141
18.7.About Error Reporting in ECP Mode.......................................................... 142
18.7.1.ECP Mode on a printer that understands PJL ................................. 142
18.7.2.ECP Mode on a printer that does not understand PJL .................... 142
18.8.Enable Power Detection ............................................................................ 143
19. Network Destination Option.................................................... 144
“Brushed-up” Functionality and Terminology ........................... 144
19.1.Requirements ............................................................................................ 144
Recommended Features for Network Target Printers.............. 144
19.2.Configurations for Each “Network Destination #”....................................... 145
19.3.Hostname (Mandatory).............................................................................. 146
19.4.Print Method (Mandatory).......................................................................... 147
Figure 15.Service Protocol vs. Print Method 147
19.5.Raw Socket TCP Port................................................................................ 148
19.6.LPR settings .............................................................................................. 149
19.6.1.Printer LPR Queue Name................................................................ 149
19.6.2.LPR Count Byte (MB) ...................................................................... 149
19.7.Changes Needed on Other Configuration Pages ...................................... 150
19.7.1.Local Printer—Do Not Enable Power Detection.............................. 150
19.7.2.System Target Printer in a “Stand-Alone” Setup ............................. 150
20. [Logical Printers 1-8] ............................................................... 151
20.1.Introduction................................................................................................ 151
20.2.Target Printer............................................................................................. 152
20.3.Load Balancing Pool.................................................................................. 153
Determining the order of values to enter.................................. 153
20.4.String Before and String After.................................................................... 155
Figure 16.Maximum number of Encoded Bytes 155
20.5.String Substitutions.................................................................................... 156
21. [Substitution Strings] .............................................................. 157