Filter
Top Products
AI296 Version 9.8x User’s Guide
Alias and Call Routing Configuration: Protocol Processing Modules
8-30
AEPX
Applied Innovation encapsulation extension is similar to AEPN, but adds the ability to
transport X.25 interrupt/reset packets and interrupt/reset confirmation packets
through TCP.
ASY
This module takes a single argument that specifies the string to be transmitted on the
outgoing connection when a call is placed. The string typically contains a modem dial
sequence.
Optional Parameters
BX25NM
The BX.25 network module is used to translate to and from the AEPN module and the
BX25S module. Typically, this module is used with the BX25S module. Refer to BX.25
Configuration on page 6-5 for information about configuring BX.25 parameters.
BX25S
The BX.25 session layer module provides the session layer to X.25 that is required for
the AMATPS protocol. Typically, this module is used with the BX25NM module. Refer
to BX.25 Configuration on page 6-5
for information about configuring BX.25
parameters.
ETER
End to end reset is used on a PVC in the data transfer state to pass reset requests
without confirmation. The endpoint is responsible for confirming the reset which is
also passed through. This option works only with PVCs and is used on the X.25 side
of the connection.
PAD
Packet assembler disassembler works with messages traveling between X.25 and
asynchronous protocols. The X.25 protocol does not use break signals, but the
asynchronous protocol does. PAD converts X.25 Q-bits into asynchronous breaks,
and vice versa.
Note: This protocol processing module can be put on an X.25 data stream.
Echo
Causes local echo from an ASY port.
Edit
Buffers calls for line editing and sends lines as a whole when ENTER is
pressed. Lines can be edited by using BACKSPACE .