Filter
Top Products
Specifying printer driver settings
3
C250P 3-18
Fold & staple
You can specify the center binding process of a document.
1 Click the Setup tab.
2 Select the “Fold & Staple” check box.
3 To specify the settings in “Fold & Staple”, click the [Details] button, and
then specify the desired settings in the Fold & Staple Details dialog box
that appears.
Fold & Staple: Specifies the conditions for center binding and folding.
Center Erase: Specifies not to print on the folded part of a document.
2
Note
“Fold & Staple” is available if optional finisher FS-603 or if saddle stitcher
SD-503 is installed on optional finisher FS-514 is installed.
“Center Erase” is available only if finisher FS-603 is installed.
The “Fold & Staple” check box cannot be selected if the “Staple” or
“Hole-Punch” check box has been selected.
The available center binding and folding settings differ depending on the
finisher that is installed. When FS-514 is installed, in addition to “Fold &
Staple” (which folds the documents in half before stapling them), “Center
Staple” (which binds documents with staples at the center) and “Fold”
(which folds documents in half) are available. When FS-603 is installed,
only “Fold & Staple” is available.