Filter
Top Products
Installation and operation precautions
1
C250P 1-20
No. Part Name Description
1 Main unit The data sent from the computer is printed.
Referred to as the “machine”, the “main unit”, or
the “C250P” throughout the manual.
2 Automatic Duplex Unit AD-503 Turns over printed pages, allowing double-sided
pages to be printed automatically.
Required to print on letterhead paper.
Referred to as the “automatic duplex unit” through-
out the manual.
3 Desk DK-502 Allows this machine to be set up on the floor.
Referred to as the “desk” throughout the manual.
4 Paper Feed Cabinet PC-103 The top tray can be loaded with up to 500 sheets of
paper, and the bottom tray can be used as storage.
Referred to as the “single paper feed cabinet”
throughout the manual.
5 Paper Feed Cabinet PC-203 Both the top and bottom trays can each be loaded
with up to 500 sheets of paper.
Referred to as the “double paper feed cabinet”
throughout the manual.
6 Paper Feed Cabinet PC-403 Can be loaded with up to 2,500 sheets of paper
Referred to as the “LCT” throughout the manual.
7 Finisher FS-603 Feeds out printed pages. The “Offset” setting (sep-
arating), Staple settings (stapling), and “Fold & Sta-
ple” function (binding) are available.
• In order to install the finisher, the main unit must
be installed on the desk, on the LCT, on the sin-
gle paper feed cabinet, or on the double paper
feed cabinet.
8 Punch Kit PK-501 Allows hole punching to be used if installed onto
Finisher FS-603.
9 Finisher FS-501 Finishes printed pages according to the selected
Output setting (sorting or stapling), then feeds out
the pages.
• In order to install the finisher, the main unit must
be installed on the desk, on the LCT, or on the
single paper feed cabinet or the double paper
feed cabinet.
10 Job Separator JS-601 Print exit tray installed on Finisher FS-501
Referred to as the “job separator” throughout the
manual.
11 Finisher FS-514 Feeds out finished printed pages. The “Sort” set-
ting (separating by copy set), “Group” setting (sep-
arating by page), and Staple settings (corner
stapling and two-point stapling) are available.
12 Output Tray OT-601 Print output tray installed onto the finisher FS-514
and used for separating printed pages
Referred to as the “optional finishing tray”
throughout the manual.
13 Punch Kit PK-510 Allows hole punching to be used if installed onto
finisher FS-514