Filter
Top Products
ADVANCED OPERATION GUIDE 3-1
3 Printer Settings
This chapter explains the procedures required to use the printer functions of the
machine.
The settings needed to use the machine as a network printer can be made from the
operation panel or using COMMAND CENTER. The procedures in this chapter only
explain how to make the settings from the operation panel. To make settings using
COMMAND CENTER, refer to Using COMMAND CENTER on page 8-1.
Parallel Setting
The parallel interface supports a bi-directional/high-speed mode according to IEEE
standards. Use a parallel printer cable that complies with the IEEE1284 standard.
Four modes are available.
1 Access Parallel Setting.
If you are unsure how to use this route map refer to Accessing Menu Items on
page vii.
2 Press S or T to select the parallel interface mode setting and press Enter.
The display shows Completed and returns to the System Setting screen.
Item Description
Auto (default) The machine automatically changes its communication
mode to that of the host computer. Ordinarily, you should
leave this setting unchanged.
Normal The machine uses the standard communication method
prescribed for Centronics interfaces.
High speed This mode enables faster data transmission between the
machine and the host computer. (Select this mode if
printing problems occur when the machine is connected
to a workstation.)
Nibble(high) High speed data communication is used in compliance
with the IEEE 1284 standard.
System Menu/
Counter
S or T
System Setting
Enter
S or T
Parallel Setting
Enter