Filter
Top Products
Working with your Lemur
28
3.2.
Interface building
Now that you know your way around the Workspace, it is time to get your
feet wet and mess around with a little Project.
3.2.1. Connecting your lemur up
The first step naturally consists in opening the connection between
JazzEditor and the Lemur. To do so, click on the Connect button on the toolbar,
which should result in opening the following window :
If you have your network set up correctly (see the chapters about
network configuration and the respective appendix), the connected Lemurs should
be listed with their IP addresses and port numbers. You can select a Lemur on the
list and click Connect to establish a connection. A double-click on the list entry
does the same trick.
If you just connected your Lemur or had it switched on shortly before,
wait a few seconds for the list to update.
Note : Be careful! If you have a Project residing on your Lemur and
connect to it with a different Project open in the JazzEditor, the one on the Lemur
will be overwritten. A connection always automatically transfers the currently
opened Project to the Lemur.
The IP and Port fields below the list allow manual entry and remember
the last setting of the Lemur connection. They also can be handy for connecting
through a proxy.