Filter
Top Products
3-184
Removal
1) Remove the FUSER ASSY. (RRP8.1)
2) Remove the BTR UNIT ASSY. (RRP8.4)
3) Remove the COVER TOP MAIN. (RRP1.4)
4) Remove the COVER ASSY FRONT HEAD. (RRP1.2)
5) Remove the COVER MSI. (RRP1.11)
6) Remove the TRAY ASSY MSI. (RRP1.12)
7) Remove the COVER ASSY FRONT. (RRP1.13)
8) Remove the COVER ASSY FRONT IN. (RRP1.10)
9) Remove the COVER SIDE L. (RRP1.14)
10) Remove the COVER SIDE R. (RRP1.9)
11) Remove the CHUTE ASSY OUT. (RRP6.1)
In the following steps, lock the FRONT ASSY IN to the printer with the latch at A to
prevent the FRONT ASSY IN from drop off.
12) Remove the connector (P/J5030) and connector (P/J5020) on the S-HVPS (PL10.1.17) from the left
side of the printer.
13) Remove the connector (P/J141), connector (P/J1361), and connector (P/J138) from the connector
bracket on the left side of the printer.
14) Shift the harness of the connectors removed above from the bottom portion of the HSG ASSY BIAS
(PL9.1.4) on the left side of the printer.
15) Remove the connector (P/J52) on the PWBA HNB DRV (PL12.1.12) on the right side of the printer.
16) Remove the connector (P/J162) on the LVPS STD (PL12.1.10) on the right side of the printer.
17) Remove 1 screw securing the WIRE ASSY FSR EARTH (PL5.1.20) on the right side of the printer.
18) Release the harness (P/J52) of the FUSER DRIVE ASSY (PL5.1.18) from the clamp on the MAIN
DRIVE ASSY (PL11.1.14).
19) Shift the harness (P/J162) of the HARNESS ASSY FSR 2 (PL5.1.9) from the hook of the housing on
the right side of the printer.
20) Release the latch at A from the printer, and pull out the FRONT ASSY IN frontward and remove.
Replacement
Replace the components in the reverse order of removal.