Filter
Top Products
Chapter 3 Removal and Replacement Procedures
3-253
RRP11.5 MAIN DRIVE ASSY (PL11.1.14)
Figure: MAIN DRIVE ASSY Removal
Removal
1) Remove the COVER TOP MAIN. (RRP1.4)
2) Remove the COVER ASSY FRONT IN. (RRP1.10)
3) Remove the COVER SIDE R. (RRP1.9)
4) Remove the LINK:R. (RRP1.8)
5) Remove the connector (P/J48) on the PWBA HNB DRV (PL12.1.12) from the right side surface of the
printer.
6) Remove the connector (P/J52) on the PWBA HNB DRV.
7) Release the harness (P/J52) from the clamp on the MAIN DRIVE ASSY on the right side surface of the
printer.
8) Remove a screw securing the edge (P/J235) of the WIRE ASSY FSR EARTH (PL5.1.20) to the MAIN
DRIVE ASSY (PL11.1.14).
9) Remove 4 screws securing the MAIN DRIVE ASSY to the printer.
10) Remove the MAIN DRIVE ASSY from the printer.
Replacement
Replace the components in the reverse order of removal.