Filter
Top Products
3-194
Removal
1) Remove the FUSER ASSY. (RRP8.1)
2) Remove the COVER TOP MAIN. (RRP1.4)
3) Remove the COVER ASSY FRONT HEAD. (RRP1.2)
4) Remove the COVER MSI. (RRP1.11)
5) Remove the TRAY ASSY MSI. (RRP1.12)
6) Remove the COVER ASSY FRONT. (RRP1.13)
7) Remove the COVER ASSY FRONT IN. (RRP1.10)
8) Remove the CHUTE ASSY EXIT. (RRP7.1)
9) Remove the COVER SIDE L. (RRP1.14)
10) Remove the COVER SIDE R. (RRP1.9)
11) Remove the STRAP. (RRP8.6)
In the following step, lock the CHUTE ASSY OUT and FRONT ASSY IN (PL5.1.1) to the
printer with the latches at A and B for drop off.
12) Remove the connector (P/J221) from the connector bracket on the left side surface of the printer.
13) Remove the connector (P/J139) from the connector bracket on the left side surface of the printer.
14) Shift the harness of the connector removed above from the bottom portion of the HSG ASSY BIAS
(PL9.1.4) on the left side surface of the printer.
15) Remove the connector (P/J50) on the PWBA HNB DRV (PL12.1.12) on the right side surface of the
printer.
16) Shift the harness (P/J50) of the HARNESS ASSY DUP (PL6.1.23) from the right side surface of the
printer.
17) Remove the RING E (PL8.1.14) on the right and left SHAFT PIVOT (PL8.1.1) securing the bottom por-
tion of the CHUTE ASSY OUT from the printer.
In the following steps, take care not to hurt your hand with burrs of the PLATE ASSY
BOTTOM MSI (PL6.1.42).
18) Pull out the left SHAFT PIVOT from the CHUTE ASSY OUT inward with radio pliers.
19) Pull out the right SHAFT PIVOT from the CHUTE ASSY OUT inward with radio pliers.
20) Release the latch at B from the printer and pull out the CHUTE ASSY OUT frontward and remove.
Replacement
Replace the components in the reverse order of removal.