Filter
Top Products
Advanced Settings
120
N150 Wireless ADSL2+ Modem Router DGN1000Bv3
2. Click the Add button.
3. In the Route Name field, type a name for this static route.
This name is for identification purposes only.
4. (Optional) To limit access to the LAN only
, select the Private check box.
If Private is selected, the static route is not reported in RIP.
5. (Optional) To prevent the route from becoming ef
fective after you click the Apply button,
clear the Active check box.
By default, the Active check box is selected and a route becomes effective after you click
the Apply button.
6. In the Destination IP Address fields, type the IP address of the final destination of the route.
7. In the IP Subnet Mask fields, type the IP subnet mask of the final destination of the route.
If the destination is a single host, type 255.255.255.255
.
8. In the Gateway IP
Address fields, type the IP address of the gateway, which needs to be on
the same LAN segment as the modem router.
9. In the Metric field, type a number from 1 through 15 as the metric value.
This value represents the number of modem routers between your network and the
destination. Usually
, a setting of 2 or 3 works, but if this is a direct connection, set it to 1.
10. Click the Apply button.
The static route is added to the table on the Static Route screen.
To change a static route:
1. Select ADVANCED > Advanced Setup > Static Routes.
The Static Routes screen displays.
2. In the table, select the radio button next to the route that you want to change.
3. Click the Edit button.
4. Change the settings for the route.
5. Click the Apply
button.
The changed settings of the route are shown in the table on the Static Routes screen.