Filter
Top Products
Security
72
N150 Wireless ADSL2+ Modem Router DGN1000Bv3
2. In the Outbound Services section, click the Add button.
3. Select the service or application to be covered by this rule.
If the service or application that you want does not display in the menu, you can define it
(see Add Custom Services to Allow or Block on page 74).
4. Select the action you want for traffic covered by this rule:
• BLOCK always. Always block the traffic covered by this rule.
• BLOCK by schedule, otherwise Allow. Allow the traf
fic covered by this rule, unless
it is blocked according to the schedule specified on the Schedule screen (see
Schedule When to Block the Internet on page 76).
• ALLOW always. Always allow the traffic covered by this rule (this selection is the
default setting).
• ALLOW by schedule, otherwise Block. Block the traffic covered by this rule, unless
it is blocked according to the schedule specified on the Schedule screen (see
Schedule When to Block the Internet on page 76
).
Note: ALLOW rules are useful only when the traffic is already covered by a
BLOCK rule. Use these rules when you want to allow a subset of traffic that is
blocked by another rule.
5. Specify which computers on your network are af
fected by this rule, based on their source
(LAN) IP address:
• Any.
All local IP addresses are covered by this rule.
• Single address
. Type the required address in the Start field.
• Address range. Type the start address for the range in the Start field and the end
address for the range in the End field.
6. Specify which Internet locations are covered by the rule, based on their destination (WAN) IP
address:
• Any.
All Internet IP addresses are covered by this rule.