Filter
Top Products
Chapter 11 – IP Service Settings
11-6
Figure 11-5 IP Service – SIP Server
Table 11-4 Configuration Description of SIP Server Parameters
Parameter Description
IP Network Type
Set the IP network type for the RMX 1000 system to make
a call. You need to set it based on the call type used for the
participant's endpoint. It can be set to:
H.323:
Only H.323 calls are supported.
SIP:
Only SIP calls are supported.
H.323 & SIP:
H.323 and SIP calls are supported at the
same time.
Settings of the SIP server related parameters are available
only when the SIP-supporting network type is selected.
Transport Type
Set the transport layer protocol used for communicating
with the SIP server. It needs to be consistent with the
protocol supported by the SIP server.
Register to Server
Specifies whether to register RMX 1000 to the specified
SIP server. You need to set the SIP server related
parameters after this function is enabled.
Primary
Server/Alternate
Server
Displays the registration status of the SIP server.
When registration of the preferred server fails, the
alternate server will function as the current in-use SIP
server.
Server Address
Provides the IP address of SIP server for registration
service.