Filter
Top Products
18-1
18
Appendix B:
Telnet/Terminal Commands
RMX 1000 also supports device debugging from the command line. You can
configure command settings in either of the following two methods: using
the HyperTerminal after connecting it to the device through a serial port or
configuring via telnet. Both methods use the same command format. Next,
we will describe how to configure command setting using the
HyperTerminal.
HyperTerminal Parameters
• Port: COM1 (basing on the port used)
• Baud rate: 115,200 bps
• Data bits: 8 bits
• Parity bit: None
• Stop bit: 1
Furthermore, you may need to set some other parameters based on the
simulation software used:
• No echo for local input
• The settings for the DEL and Backspace keys
• Enter/New line
• The simulation type for the endpoint: Automatic or ANSI
Login
If you have completed all the above configurations and launched the
HyperTerminal simulation software successfully, press the Enter key. The
login interface appears.
The login interface shows all of the software information and you’ll be
prompted to enter the login password. Now enter the login password and
press the Enter key.
The factory default login password is POLYCOM (case sensitive).