Polycom RMX 1000 User Guide
2-7
Parameter Description
LAN Speed
Sets the speed/duplex modes for LAN ports. Supported
speed/duplex modes include 10/100M, Full Duplex or Half
Duplex, and the 1000M Network mode. You can also
select
Auto
to use Auto-Negotiation with the switch port.
Note:
Contact the network administrator before setting LAN
Speed, to ensure that the switch configuration is matched
with the MCU port.
MTU Size
Specifies the Maximum Transmission Unit (MTU) size
used in IP calls and Web communications. If the video
becomes blocky or network errors occur, packets may be
too large; decrease the MTU. If the network is burdened
with unnecessary overhead, packets may be too small;
increase the MTU.
Configuring Other Network Options (Optional)
If necessary, you can configure other network parameters according to the
following procedure:
1 Click the IP Network Services configuration item in the RMX
Management pane.
2 In the IP Network Services configuration pane, double-click or right-click
LAN 1 -> Properties.
3 Click the Routers tab, and set the routing table information according to
the network topology.
Figure 2-8 IP Network Services – Route Settings
Table 2-2 Routers Setting
Parameter Description
Router IP Address
Set the IP address for the sending router of packet
transmission.