Renesas R61509V Computer Monitor User Manual


 
R61509V Target Spec
Rev. 0.11 April 25, 2008, page 16 of 181
PROTECT I
Host
processor
Reset protect pin. The R61509V enters a reset protect status by
fixing PROTECT to GND level disabling hardware reset. With
this, erroneous operations caused by noise are prevented.
Low: Hardware reset is disabled (Reset protect status)
High: Hardware reset is enabled. (Normal status)
IOVCC
Table 7 Internal Power Supply Circuit
Signal I/O
Connect
to
Function
When
not
used
VDD O
Stabilizing
capacitor
Output from internal logic regulator. Connect to a stabilizing
capacitor.
VCI1 O
Stabilizing
capacitor
Reference voltage for step-up circuit 1. Make sure that DDVDH,
VGH and VGL output voltages do no go exceed the ratings.
DDVDH O
Stabilizing
capacitor
Power supply for the source driver liquid crystal drive unit and
VCOM drive. Connect to a stabilizing capacitor.
VGH O
Stabilizing
capacitor
Power supply for the gate driver liquid crystal drive unit.
Connect to a stabilizing capacitor.
VGL O
Stabilizing
capacitor
Power supply for the gate driver liquid crystal drive unit.
Connect to a stabilizing capacitor.
VCL O
Stabilizing
capacitor
Power supply for VCOML drive.
C11P,
C11M,
C12P,
C12M
I/O
Step-up
capacitor
Make sure to connect capacitors for internal step-up circuit 1.
C13P,
C13M,
C21P,
C21M,
C22P,
C22M
I/O
Step-up
capacitor
Make sure to connect capacitors for internal step-up circuit 2.