Filter
Top Products
R61509V Target Spec
Rev. 0.11 April 25, 2008, page 55 of 181
Panel Interface Control 2 (R011h)
R/W RS IB15 IB14 IB13 IB12 IB11 IB10 IB9 IB8 IB7 IB6 IB5 IB4 IB3 IB2 IB1 IB0
R/W 1 0 0 0 0 0
NOW
I[2]
NOW
I[1]
NOW
I[0]
0 0 0 0 0
SDTI
[2]
SDTI
[1]
SDTI
[0]
Default 0 0 0 0 0 0 0 1 0 0 0 0 0 0 0 1
NOWI[2:0]: Sets the non-overlap period of adjacent gate outputs. The setting is enabled when the
R61509V’s display operation is synchronized with internal clock signals.
Table 24
NOWI[2:0] Non-overlap period NOWI[2:0] Non-overlap period
3'h0 0 (internal clock
*see note
) 3'h4 4 (internal clock
*see note
)
3'h1 1 3'h5 5
3'h2 2 3'h6 6
3'h3 3 3'h7 7
Note: The internal clock is the frequency divided clock, which is set by DIVI[[1:0] bits.
SDTI[2:0]: Sets the source output delay period from the reference point. For the relationships between
gate interface signals, see Liquid Crystal Panel Interface Timing.
Table 25
SDTI[2:0] Source output delay period
3’h0 0 clocks
3’h1 1 clock
3’h2 2 clocks
3’h3 3 clocks
3’h4 4 clocks
3’h5 5 clocks
3’h6 6 clocks
3’h7 7 clocks
Notes: 1. The number of clocks in the table setting is measured from the reference point.
2. 1 clock = (internal oscillation clock (OSC1) period) x (division ratio)
3. The reference point is the falling edge of gate output.