Renesas R61509V Computer Monitor User Manual


 
R61509V Target Spec
Rev. 0.11 April 25, 2008, page 174 of 181
LCD Driver Output Characteristics
Table 92
Item Symbol Unit Test condition Min. Typ. Max. Note
Source driver
output delay time
tdds µs
VCC=IOVCC =2.80V, VC[2:0]=3’h7
VRH[4:0]=5’h1F,
fosc=678kHz (432-line drive), Ta=25°C,
PR*P00=PR*N00=5’h00,
PR*P01=PR*N01=5’h02,
PR*P02=PR*N02=5’h04,
PR*P03=PR*N03=4’h8,
PR*P04=PR*N04=4’hF,
PR*P05=PR*N05=4’h8,
PR*P06=PR*N06=5’h04,
PR*P07=PR*N07=5’h02,
PR*P08=PR*N08=5’h04,
PIR*P0= PIR*P1= PIR*P2= PIR*P3=2'h0
PIR*N0= PIR*N1= PIR*N2= PIR*N3=2'h0
Same change from the same grayscale at
all time-division source output pins.
Time to reach the target voltage ±35mV
from VCOM polarity inversion timing.
R=10kohm, C=30pF
25
(TBD)
10
VCOM output
delay time
tddv µs
VCC=IOVCC=2.80V, VC[2:0]=3’h7,
VRH[4:0] =5’h1F,
fosc=678kHz (432-line drive), Ta=25°C,
PR*P00=PR*N00=5’h00,
PR*P01=PR*N01=5’h02,
PR*P02=PR*N02=5’h04,
PR*P03=PR*N03=4’h8,
PR*P04=PR*N04=4’hF,
PR*P05=PR*N05=4’h8,
PR*P06=PR*N06=5’h04,
PR*P07=PR*N07=5’h02,
PR*P08=PR*N08=5’h04,
PIR*P0= PIR*P1= PIR*P2= PIR*P3=2'h0
PIR*N0= PIR*N1= PIR*N2= PIR*N3=2'h0
Time to reach ±35mV when shifting
between source 0V63 in the worst
case of scenario.
R=100ohm, C=10nF
25
(TBD)
11
Reset Timing Characteristics
Table 93
IOVCC=1.65V
3.30V
Item Symbol Unit Test condition Min. Typ. Max.
Reset ”Low” level width tRES ms Figure C 1
Reset rise time trRES µs Figure C 10