Filter
Top Products
7.8
Troubleshooting
CID NUM. EMPTY You have attempted to
register a junk fax number
when the CID list is empty.
The CID list is created when
Caller Line Identification
service is available. Make sure
that you have subscribed to
the service and there is a
number in the CID list.
LINE ERROR Your unit cannot connect
with the remote machine,
or has lost contact because
of a problem on the phone
line.
Try again. If failure persists,
wait an hour or so for the line
to clear, and try again.
Or, turn the ECM mode on.
See “Fax Setup Options” on
page 5.41.
LOAD DOCUMENT You have attempted to set
up a sending operation
with no document loaded.
Load a document and try
again.
MEMORY FULL The memory is full. Either delete unnecessary
documents, or retransmit
after more memory becomes
available, or split the
transmission into more than
one operation.
MEMORY JOB
NOT ASSIGNED
You attempted to add
documents when there is
no scheduled job.
Check the display if there is
any scheduled job. The
display should indicate the job
in Standby mode (for
example, DELAY TX or SAVE
TOLL).
NO ANSWER The remote machine has
not answered after all the
redial attempts.
Try again. Make sure the
remote machine is
operational.
NO. NOT ASSIGNED The one-touch or speed
dial location you tried to
use has no number
assigned to it.
Dial the number manually
with the keypad, or assign a
number.
PC NOT AVAILABLE Your product is not
properly connected to your
PC.
Check the cable connection
between the product and the
PC. Connect properly using a
parallel or USB cable. See 1.7.
LCD Display Meaning Solution