Filter
Top Products
P
ORT
C
ONFIGURATION
3-121
“Configuring Interface Connections” on page 3-48.) The following
capabilities are supported.
- 10half - Supports 10 Mbps half-duplex operation
- 10full - Supports 10 Mbps full-duplex operation
- 100half - Supports 100 Mbps half-duplex operation
- 100full - Supports 100 Mbps full-duplex operation
- 1000full - Supports 1000 Mbps full-duplex operation
- 10Gfull - Supports 10 Gbps full-duplex operation
• Broadcast storm – Shows if broadcast storm control is enabled or
disabled.
• Broadcast storm limit – Shows the broadcast storm threshold. (500 -
262143 packets per second)
• Flow control
8
– Shows if flow control is enabled or disabled.
• LACP – Shows if LACP is enabled or disabled.
• Port security – Shows if port security is enabled or disabled.
• Max MAC count – Shows the maximum number of MAC address that
can be learned by a port. (0 - 1024 addresses)
• Port security action – Shows the response to take when a security
violation is detected. (shutdown, trap, trap-and-shutdown)
• Media type – Shows the forced/preferred port type to use for
combination ports 21-24 (SMC8724ML3) or 45-48 (SMC8748ML3).
(copper forced, SFP forced, SFP preferred auto)
Current status:
• Link status – Indicates if the link is up or down.
• Port operation status – Provides detailed information on port state.
(Displayed only when the link is up.).
• Operation speed-duplex – Shows the current speed and duplex mode.
• Flow control type – Indicates the type of flow control currently in use.
(IEEE 802.3x, Back-Pressure or none)
8. There are interoperability problems between Flow Control and Head-of-Line (HOL) blocking for the
switch ASIC; Flow Control is therefore not supported for this switch.