IP R
OUTING
C
OMMANDS
4-359
Related Commands
ip ospf authentication (4-356)
ip ospf cost
This command explicitly sets the cost of sending a packet on an interface.
Use the no form to restore the default value.
Syntax
ip ospf cost cost
no ip ospf cost
cost - Link metric for this interface. Use higher values to indicate
slower ports. (Range: 1-65535)
Command Mode
Interface Configuration (VLAN)
Default Setting
1
Command Usage
Interface cost reflects the port speed. This router uses a default cost of 1
for all ports. Therefore, if you install a Gigabit module, you may have to
reset the cost for all of the 100 Mbps ports to a value greater than 1.
Example
Console(config)#interface vlan 1
Console(config-if)#ip ospf cost 10
Console(config-if)#