Filter
Top Products
C
OMMAND
L
INE
I
NTERFACE
4-330
ip rip receive version
This command specifies a RIP version to receive on an interface. Use the no
form to restore the default value.
Syntax
ip rip receive version {none | 1 | 2 | 1 2}
no ip rip receive version
• none - Does not accept incoming RIP packets.
• 1 - Accepts only RIPv1 packets.
• 2 - Accepts only RIPv2 packets.
• 1 2 - Accepts RIPv1 or RIPv2 packets
Command Mode
Interface Configuration (VLAN)
Default Setting
The default depends on the setting specified with the version command:
• Global RIPv1 - RIPv1 or RIPv2 packets
• Global RIPv2 - RIPv2 packets
Command Usage
• Use this command to override the global setting specified by the RIP
version command.
• You can specify the receive version based on these options:
- Use “none” if you do not want to add any dynamic entries to the
routing table for an interface. (For example, you may only want to
allow static routes for a specific interface.)
- Use “1” or “2” if all routers in the local network are based on RIPv1
or RIPv2, respectively.
- Use “1 2” if some routers in the local network are using RIPv2, but
there are still some older routers using RIPv1.