Filter
Top Products
C
OMMAND
L
INE
I
NTERFACE
4-360
ip ospf dead-interval
This command sets the interval at which hello packets are not seen before
neighbors declare the router down. Use the no form to restore the default
value.
Syntax
ip ospf dead-interval seconds
no ip ospf dead-interval
seconds - The maximum time that neighbor routers can wait for a hello
packet before declaring the transmitting router down. This interval
must be set to the same value for all routers on the network. (Range:
1-65535)
Command Mode
Interface Configuration (VLAN)
Default Setting
40, or four times the interval specified by the ip ospf hello-interval
command.
Example
Related Commands
ip ospf hello-interval (4-361)
Console(config)#interface vlan 1
Console(config-if)#ip ospf dead-interval 50
Console(config-if)#