Filter
Top Products
IP R
OUTING
C
OMMANDS
4-327
network
This command specifies the network interfaces that will be included in the
RIP routing process. Use the no form to remove an entry.
Syntax
[no] network subnet-address
subnet-address – IP address of a network directly connected to this
router.
Command Mode
Router Configuration
Default Setting
No networks are specified.
Command Usage
• RIP only sends updates to interfaces specified by this command.
• Subnet addresses are interpreted as class A, B or C, based on the first
field in the specified address. In other words, if a subnet address
nnn.xxx.xxx.xxx is entered, the first field (nnn) determines the class:
- 0 - 127 is class A, and only the first field in the network address is used.
- 128 - 191 is class B, and the first two fields in the network address are
used.
- 192 - 223 is class C, and the first three fields in the network address
are used.
Example
This example includes network interface 10.1.0.0 in the RIP routing process.
Related Commands
router rip (4-325)
Console(config-router)#network 10.1.0.0
Console(config-router)#