Filter
Top Products
C
OMMAND
L
INE
I
NTERFACE
4-200
Mirror Port Commands
This section describes how to mirror traffic from a source port to a target
port.
Table 4-49 show interfaces switchport - display description
Field Description
Broadcast threshold Shows if broadcast storm suppression is enabled or disabled;
if enabled it also shows the threshold level (page 4-194).
LACP status Shows if Link Aggregation Control Protocol has been enabled
or disabled (page 4-206).
Ingress/Egress rate
limit
Shows if rate limiting is enabled, and the current rate limit
(page 4-203).
VLAN membership
mode
Indicates membership mode as Trunk or Hybrid
(page 4-250).
Ingress rule Shows if ingress filtering is enabled or disabled (page 4-252).
Acceptable frame
type
Shows if acceptable VLAN frames include all types or tagged
frames only (page 4-251).
Native VLAN Indicates the default Port VLAN ID (page 4-253).
Priority for untagged
traffic
Indicates the default priority for untagged frames
(page 4-269).
GVRP status Shows if GARP VLAN Registration Protocol is enabled or
disabled (page 4-266).
Allowed VLAN Shows the VLANs this interface has joined, where “(u)”
indicates untagged and “(t)” indicates tagged (page 4-254).
Forbidden VLAN Shows the VLANs this interface can not dynamically join via
GVRP (page 4-255).
Table 4-50 Mirror Port Commands
Command Function Mode Page
port monitor Configures a mirror session IC 4-201
show port monitor Shows the configuration for a mirror port PE 4-202