C
OMMAND
L
INE
I
NTERFACE
4-382
vrrp ip
This command enables the Virtual Router Redundancy Protocol (VRRP) on
an interface and specify the IP address of the virtual router. Use the no form
to disable VRRP on an interface and remove the IP address from the virtual
router.
Syntax
[no] vrrp group ip ip-address [secondary]
• group - Identifies the virtual router group. (Range: 1-255)
• ip-address - The IP address of the virtual router.
• secondary - Specifies additional secondary IP addresses assigned to
the current VLAN interface that are supported by this VRRP group.
Default Setting
No virtual router groups are configured.
Command Mode
Interface (VLAN)
Command Usage
• The interfaces of all routers participating in a virtual router group must
be within the same IP subnet.
show vrrp
interface
Displays VRRP status information for the
specified interface
PE 4-389
show vrrp router
counters
Displays VRRP statistics PE 4-390
show vrrp
interface counters
Displays VRRP statistics for the specified
interface
PE 4-391
clear vrrp router
counters
Clears VRRP router statistics PE 4-391
clear vrrp interface
counters
Clears VRRP interface statistics PE 4-392
Table 4-102 VRRP Commands (Continued)
Command Function Mode Page