IP I
NTERFACE
C
OMMANDS
4-307
IP Interface Commands
There are no IP addresses assigned to this router by default. You must
manually configure a new address to manage the router over your network or
to connect the router to existing IP subnets. You may also need to a establish
a default gateway between this device and management stations or other
devices that exist on another network segment (if routing is not enabled).
This section includes commands for configuring IP interfaces, the Address
Resolution Protocol (ARP) and Proxy ARP. These commands are used to
connect subnetworks to the enterprise network.
Basic IP Configuration
Table 4-77 IP Interface Commands
Command Group Function Page
Basic IP
Configuration
Configures the IP address for interfaces and the
gateway router
4-307
Address Resolution
Protocol (ARP)
Configures static, dynamic and proxy ARP service 4-313
Table 4-78 Basic IP Configuration Commands
Command Function Mode Page
ip address Sets the IP address for the current interface IC 4-308
ip default-gateway Defines the default gateway through which this
router can reach other subnetworks
GC 4-310
show ip interface Displays the IP settings for this device PE 4-311
show ip redirects Displays the default gateway configured for
this device
PE 4-311
ping Sends ICMP echo request packets to another
node on the network
NE,
PE
4-312